A townhome & pud association in RI has to satisfy two things at once: the coverage architecture specific to townhome & pud communities, and RI's own statutory and lender-warrantability requirements.
Coverage architecture turns on whether the building is insured per structure or under one blanket limit, and on how cleanly the shared party wall is allocated between adjoining owners.
RI · Townhome & PUD
RI Townhome & PUD Insurance
A townhome & pud community in RI sits at the intersection of two coverage questions. The first is structural to the association type: coverage architecture turns on whether the building is insured per structure or under one blanket limit, and on how cleanly the shared party wall is allocated between adjoining owners. The second is jurisdictional: RI's statute, its lender-warrantability climate, and its market conditions shape how that program has to be sized, documented, and placed. This page covers both, and how they meet.
The coverage architecture
What drives a townhome & pud master policy
Townhome and planned-unit-development programs sit in a different structural category than condo master policies because ownership usually runs to the ground beneath the unit rather than to an airspace boundary inside a larger building. That changes the first architecture question from valuation basis to insuring structure: does the association carry a single blanket property limit across every building in the community, or does each building (or each unit) get insured individually. A blanket limit spreads risk and simplifies claims administration, but it needs periodic reconciliation against actual replacement cost as the community adds buildings or as construction costs move, or the aggregate limit quietly falls behind total exposure.
The party wall or shared wall between attached townhome units is the exposure a detached single-family HOA never has to think about and a high-rise condo handles completely differently, because a townhome party wall sits inside one structure shared by two separately owned units rather than inside a single building owned entirely by the association. Governing documents typically assign the association responsibility for the party wall and the exterior structure while leaving unit interiors to the owner, similar in spirit to a condo's bare-walls basis but built around attached, ground-up construction instead of a stacked building. A fire or water loss that starts in one unit and crosses the party wall creates a subrogation and cost-allocation question between the association's policy, the affected owner's HO-6 or landlord policy, and the neighboring owner's policy, and that allocation should be worked out in the governing documents and the insurance program together, not improvised after a claim.
PUD common areas, private streets, retention ponds, entry monuments, community mailboxes, and small shared amenities, carry general liability and property exposure similar in kind to a single-family HOA's amenity risk, but layered on top of the attached-structure property questions above. Directors and officers coverage and a fidelity bond round out the program the same way they do for any association, sized to the community's reserves and monthly assessment volume.
•Party-wall and shared-wall fire or water loss crossing between two separately owned attached units
•Blanket versus per-building or per-unit property valuation falling out of sync with actual replacement cost as the community grows
•Ambiguity in governing documents over which party (association, owner, or neighboring owner) is responsible for a party-wall loss
•Directors and officers liability for the volunteer board
•Fidelity/crime bond sized to reserves and monthly assessment volume
RI statutory backdrop
How RI law shapes the program
For condominiums, Rhode Island General Laws Section 34-36.1-3.13 requires the association to maintain property insurance on the common elements against all risks of direct physical loss, or in the case of a conversion building against fire and extended coverage perils, in a total amount after deductibles of not less than 80 percent of the actual cash value of the insured property at each renewal, exclusive of land, excavations, foundations, and other normally excluded items, plus liability insurance in an amount set by the executive board and not less than any amount the declaration specifies.
That 80 percent actual-cash-value floor is the key practitioner point. It is below the 100 percent replacement-cost standard the Fannie Mae Selling Guide requires for a conventional loan to be warrantable. A Rhode Island association can satisfy Section 34-36.1-3.13 and still fail a lender insurance review, so size the property program to the lender bar rather than the statutory minimum, and confirm the coverage is written on replacement cost rather than actual cash value.
Rhode Island also carries a distinctive deductible provision. Under the statute, a unit owner's own policy becomes the primary insurance for any loss to the unit that the association's policy would cover but does not pay because of the master deductible. That makes the interaction between the master policy deductible and each owner's HO-6 policy a real compliance item, not a footnote, and boards should make sure owners actually carry loss-assessment and matching coverage. The Condominium Law generally governs condominiums created after its 1982 effective date, with a separate older chapter covering condominiums formed before it, so confirm which chapter applies to a specific building.
For the full RI picture, including reserve and inspection requirements and market commentary, see the RI state page. For how townhome & pud coverage is built regardless of state, see the Townhome & PUD practice page.
Load-bearing clauses
The clauses that decide a townhome & pud claim
→Insuring structure: blanket limit across all buildings versus per-building or per-unit valuation
→Party-wall/shared-wall responsibility and cost allocation between adjoining owners
→Common-area and private-infrastructure general liability (streets, retention, shared amenities)
→Fidelity/crime bond sized to reserves and assessments
→Directors and officers liability for the volunteer board
Townhome & PUD insurance: what boards and managers ask
Who is responsible for insuring a shared party wall between attached townhome units?
It depends on how the governing documents assign responsibility, and that assignment should match the insurance program rather than being left to be argued after a loss. Many townhome declarations put the association in charge of the party wall and exterior structure while leaving unit interiors to the individual owner's policy, similar in concept to a condo bare-walls basis but built around attached ground-up construction. A fire or water loss that crosses the party wall between two units can trigger claims against the association's policy, both owners' individual policies, and a subrogation question between insurers, so the declaration language and the master policy need to agree on where the boundary sits before a loss, not during one.
Should a townhome or PUD association insure each building separately or under one blanket limit?
Both approaches are common, and the right answer depends on the community's size and how consistently its buildings were constructed. A single blanket limit across all buildings is simpler to administer and smooths out the loss experience, but it needs to be reconciled periodically against actual current replacement cost as the community adds phases or construction costs rise, or the aggregate limit can fall behind total exposure without the declarations page ever flagging it. Per-building or per-unit valuation is more precise but requires more maintenance at each renewal.
Free coverage review
A specialist will review your townhome & pud program against RI's requirements within one business day.
Send your declarations page and governing documents. You get a plain-English, requirement-by-requirement review, not a sales call.